People up information: laser welding machine for welding glass frame
Frames laser welding machine is a new type of welding, laser welding secondary for thin wall materials, fine welding parts, can complete the spot welding, butt welding, welding stack, seal welding, etc. , deep wide ratio is high, the weld width is small, small heat affected zone, small deformation, welding speed, welding seam smooth, beautiful, without disposal or simply complex treatment after welding, the weld quality is high, no pores, can accurate control, focusing on small points of light, high positioning accuracy, easy to complete automation. Don't usually use filling solder, thus fitting clearance between the parts to be less than 15% of the thickness of the precision parts. Parts of each local are absolutely clean, because the welding is very fast, too late to burn away impurities. Spectacle frame laser welding machine in a handful of active metal welding gas requires maintenance, but many alloy can also stop the welding in the air. Welding of heat energy output and solder joint shape can be controlled by parameters and components, identify stop welding heat transfer form, fusion welding, welding and small holes through them. The range of depth shallow, heat conduction welding is wide, similar to GTAW or TIG weld appearance. This welding is often used in some small parts, and tools, for instance, may relay tank electronics and batteries, they demand welds and smooth, beautiful appearance. Spectacle frame laser welding machine form of penetration weld depth and weld width equal or slightly deeper than the width. Using form of fusion welding, the heat energy output is small, small and deep pool, can use less uniform. Due to welding cycle to maintain the demand of the small hole, hole form welding only continue or the super form a continuation of the laser. High hole welding molten pool depth width ratio to 6:1, is a high efficiency welding process. The continuation of the laser pulse, continue, super form can task off in the form of heat conduction, can use continuation of laser fusion form, and as long as the super form the continuation of laser welding form can be used for small holes through them.