Laser marking machine troubleshooting and semiconductor laser marking machine

by:cycjet     2020-07-23
If laser marking machine software can't normal use to do, this is all the people who use laser marking machine is worry about a thing, don't have to worry about it, if the marking software open automatically close the case, you need not worry, may be encrypted dog is not installed properly, you only need to reinstall it again can encrypt a dog, if the problem appeared in the encryption dog driver, so as long as the dog reinstall encryption driver is ok, as long as remember, either dogs or encryption dog installer, reinstall after must restart once, in order to ensure the normal operation of the software. If the target size problems, then you have to look at the problem appeared in where, is exported to laser marking machine software itself graphics is wrong, wrong size or set the initial size generally, simple graphics, can be directly modified on marking software, layout of complex graphics will need to reset the, because direct tamper with the easy to deformation graphics or design. In front of the laser marking system diagram again, be sure to adjust the proportion of the graphic again parameters, then check the focal length, to see if it changes, is there any necessary to make the adjustment of the focal length, if the marking, mark the effect is not ideal, design or font, have the shadow around or asymmetry phenomenon, shall carefully check and see if it is marking the cause of the software itself or cause of the breakdown of the computer system, the processing of this time is the most simple way is to reinstall system or marking software. If the target size problems, then you have to look at the problem appeared in where, is exported to laser marking machine software itself graphics is wrong, wrong size or set the initial size generally, simple graphics, can be directly modified on marking software, layout of complex graphics will need to reset the, because direct tamper with the easy to deformation graphics or design. Again before drawing again, be sure to adjust the proportion of graphics parameters, then check the focal length, to see if it changes, is there any necessary ultraviolet laser marking machine to make the adjustment of the focal length, if the marking to mark the effect is not ideal, design or font, have the shadow around or asymmetry phenomenon, shall carefully check and see if it is marking the cause of the software itself or the cause of the problem of computer systems, this time is the most simple way is to reinstall the system or marking software. If you do you feel trouble, that you'll have to check the marking of the software system parameter set, to see if the laser marking machine galvanometer no debug, whether to need to change, sometimes a problem actually is not necessarily a laser marking machine, may also is playing the underlying graphics do not up to standard or to the underlying material quality is bad, sometimes not rule out the possibility of operating personnel's error, check carefully before each use, serious operation, avoid laser marking machine software problems in the work of the intermediate links. What are the advantages of the semiconductor laser marking machine. The advantages of optical fiber laser marking machine which has a lot of wrong we introduce and analyze them one by one, and then take a few particularly important for good. Type 1, semiconductor laser marking machine laser beam special good, when using the conversion speed, at the same time when use small power consumption, convenient maintenance and use. 2, the use of life than the traditional laser marking machine for longer, can save the basis of our initial cost, also can be a long time operation, because the game written marking machine is not able to work for a long time, once after work for a long time, easy to cause machine damage or some inevitable failure, and the semiconductor laser marking machine is not like this. 3, the switching time is short, can be applied to communications, for use as a boot time stability performance is very high, use on the output of the circuit is very appropriate. 4, operation process is very simple, but simple operation will not affect of quality, on the contrary it hit the mark of the quality is very high, at the same time, small volume can facilitate people to carry and use. Shenzhen citizen laser technology co. , LTD. Is a company committed to global customers with laser equipment and laser intelligent solutions high-tech enterprises, the company mainly research and development production _ _ _ laser marking machine - sales Laser welding machine Laser cutting machine - Laser engraving machine, the hotline: 400 - 009 - 8266 http: / / www。 szmslaser。 com/。
Custom message
Chat Online
Chat Online
Chat Online inputting...