Laser marking machine correct installation and operation points for attention!
Laser marking machine correct installation and operation points for attention! U don't place the equipment operation environment in high humidity, dust, or there is the place of the steam flow. < This may result in fire or electric shock.> U don't put equipment in high temperature, especially in the equipment exposed to direct sunlight or near the heater. < This could lead to a component or device surface fire or deterioration.> U carry on maintenance, disconnect the power plug from the socket. < This may result in electric shock.> When u do not use the equipment for a long time, please disconnect the power plug. < This may result in fire & gt; When u mobile device, please remove the power cord and other cables. < This may result in equipment damage, fire, personal injury or get an electric shock.> Before u disconnect the power cord and other cables, be sure to shut off the power. < This may result in equipment damage or shock.> Don't hold u disconnect the power cord cable, holding the plug. < This may result in fire or electric shock.> U don't disconnect the power plug with wet hand. < This may result in electric shock.> U don't let the power cord near a heater. < This may result in fire or electric shock.> U do not place any object on the equipment under the condition of mobile devices. < This may lead to injury.> U do not place any object on the device. < This may result in fire or electric shock.> U don't close the vent. < This may result in equipment damage or fire.> U please shut off the power when clean the lens. < This may lead to injury.> Install exhaust and air purifier, because laser marking some materials may produce poisonous smoke or particles, and dust within the equipment may result in failure or fire. Please turn off the power when clean lens, otherwise it may cause harm to human body. Please don't put your hands on laser marking area. In addition, the need to prepare the optical density of 5 or more than 5, the wavelength of 1064 nm protective glasses ( Pay attention to safety glasses degrade over time, suggest that regular replacement) , do not modify, heating, excessive force to bend, distortion, or stretch, or place heavy objects on optical fiber line above, which may lead to optical fiber line is damaged, fiber optic cable sets minimum bending radius of 150 mm or larger, fiber optic cable bending, extrusion, stretching and heat will not only lead to failure, but can't keep instrument performance.